{"id":25624,"date":"2021-07-15T13:38:55","date_gmt":"2021-07-15T13:38:55","guid":{"rendered":"https:\/\/ghinduction.com\/news\/automatic-inductor-change-in-cable-preheater\/"},"modified":"2023-11-16T16:36:03","modified_gmt":"2023-11-16T16:36:03","slug":"automatic-inductor-change-in-cable-preheater","status":"publish","type":"news","link":"https:\/\/ghinduction.com\/pt-pt\/news\/automatic-inductor-change-in-cable-preheater\/","title":{"rendered":"NEW! Automatic inductor change in cable preheating"},"content":{"rendered":"

GH Induction has launched the first system of inductive conductor preheater with automatic inductor change.<\/span><\/p>\n

It is the latest technology to prevent human errors in production and increase production reliability in CCV and CVC production lines for MF and HF cables.<\/p>\n

Preheating of conductors<\/h2>\n

Inductive preheating of conductors is used for applying insulation layers (extrusion) to achieve high quality insulation at high production speeds.<\/p>\n

Why is inductive heating so important in this process?<\/strong><\/p>\n

In order to apply the cross-linked polyethylene (XLPE, XLPE) insulation, it is extremely important to cure it homogeneously. There may be gaps in the material which may lead to insulation breakdown due to the high voltage flowing through the cable.<\/p>\n

\"Cable<\/a>
Cable copper layers – Property of Vatan Kablo<\/figcaption><\/figure>\n

This layer is relatively thick, so it is difficult to cure the insulation only from the outside. In this case, it would be necessary to run the cable through a long heater at a very slow speed to cure the material. However, if the conductor is heated before the insulation layer is applied, the insulation material is also indirectly heated from the inside by the heat given off by the conductor. With induction heating, it is therefore possible to apply a homogeneously cured insulation layer at a high production rates.<\/p>\n

Benefits of the automatic inductor change preheater<\/strong><\/h2>\n
    \n
  • Error prevention: <\/strong>\n
      \n
    • Avoidance of failure due to incorrectly connected coil assemblies (too tight \/ too weakly tightened).<\/li>\n
    • Avoidance of failure due to the use of the wrong inductor (configuration “fully automatic”).<\/li>\n
    • Avoiding water leaks due to not having to reconnect water lines.<\/li>\n<\/ul>\n<\/li>\n
    • Ergonomics<\/strong>: The inductor does not have to be changed with the aid of a crane or physically lifting. The risk of injury to employees is reduced to a minimum.<\/li>\n
    • Process automation: <\/strong>The heating can be controlled and monitored remotely.<\/li>\n
    • Storage: <\/strong>The inductors can be stored directly on the rack<\/li>\n<\/ul>\n

      You can read a complete article in the specialized wire and cable magazine, Draht (in German).<\/p>\n

      In English, click here.<\/a><\/p>\n